OldSkool Suzuki .infoBoard - Draw Thru, Carb to Turbo question

	Welcome! It's 09. Sep 2010 at 14:02 and Don't forget to check the NEWS PAGE for updates!

OldSkool Suzuki .infoBoard › Discussions › Forced induction
(Moderators: Proffie, Fred)

‹ Previous topic | Next topic ›

Pages: 1

Draw Thru, Carb to Turbo question (Read 255 times)

nasherr Dino-egg Oldskool Rulez! Posts: 26 Gender:	Draw Thru, Carb to Turbo question 24. Jun 2009 at 21:41 Looking for advice, wot to do for best, Turbo inlet OD is 60mm, Carb outlet OD is 50mm, Question is, do i need a 60mm to 50mm ally step reducer making up? or can I use a silicone reducer of this size? I am wondering if the silicone reducer would collapse inwards cheers nasherr
Back to top	IP Logged

Ex Member

Re: Draw Thru, Carb to Turbo question
Reply #1 - 24. Jun 2009 at 22:48

if ya going to use silicone ..make sure u use fuel resistant hose ..., silicone will be fine as normal to use three layer hose on turbo setup ..it wont collapse as its too short , well keep it short as poss , or easy enough to get a alloy reducer made as well , choise is yours ...tip tho short as possible ...draw thrus can be setup to run like stock bike ...

IP Logged

nasherr Dino-egg Oldskool Rulez! Posts: 26 Gender:	Re: Draw Thru, Carb to Turbo question Reply #2 - 25. Jun 2009 at 14:10 Cheers for that f,
Back to top	IP Logged

conger Allosaurus Mummy I am scared Posts: 526 Gender:	Re: Draw Thru, Carb to Turbo question Reply #3 - 05. Jul 2009 at 22:39 get a bigger carb
Back to top	I'll build a drag bike! What the fuck have i gone and done? IP Logged

Pages: 1

OldSkool Suzuki .infoBoard › Discussions › Forced induction
(Moderators: Proffie, Fred)

‹ Previous topic | Next topic ›